- QUALCOMM QCA9377 802.11AC WIRELESS ADAPTER DRIVER INSTALL
- QUALCOMM QCA9377 802.11AC WIRELESS ADAPTER DRIVER DRIVER
- QUALCOMM QCA9377 802.11AC WIRELESS ADAPTER DRIVER SOFTWARE
LnkCtl2: Target Link Speed: 2.5GT/s, EnterCompliance- SpeedDis. LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-ĭevCap2: Completion Timeout: Not Supported, TimeoutDis+, LTR+, OBFF Via messageĭevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR-, OBFF Disabled LnkCtl: ASPM Disabled RCB 64 bytes Disabled- CommClk-ĮxtSynch- ClockPM- AutWidDis- BWInt- AutBWInt. LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1, Exit Latency L0s <4us, L1 <64usĬlockPM+ Surprise- LLActRep- BwNot- ASPMOptComp+ MaxPayload 128 bytes, MaxReadReq 512 bytesĭevSta: CorrErr- UncorrErr- FatalErr- UnsuppReq- AuxPwr+ TransPend. RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop. Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-Ĭapabilities: MSI: Enable- Count=1/8 Maskable+ 64bit-Ĭapabilities: Express (v2) Endpoint, MSI 00ĭevCap: MaxPayload 256 bytes, PhantFunc 0, Latency L0s unlimited, L1 <64usĮxtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset- SlotPowerLimit 0.000WĭevCtl: Report errors: Correctable- Non-Fatal- Fatal- Unsupported. Region 5: Memory at (32-bit, non-prefetchable) Ĭapabilities: Power Management version 3įlags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0+,D1-,D2-,D3hot+,D3cold+) Region 4: Memory at (32-bit, non-prefetchable) Region 3: Memory at (32-bit, non-prefetchable) * # TAbort- SERR- (32-bit, non-prefetchable) Supported Channel Width: neither 160 nor 80+80 Minimum RX AMPDU time spacing: 8 usec (0x06) Maximum RX AMPDU length 65535 bytes (exponent: 0x003) I just assumed it shared a common driver/firmware with one of the other QCA9377 chipsets. I couldn't find my exact card on WikiDevi or anything either.
QUALCOMM QCA9377 802.11AC WIRELESS ADAPTER DRIVER SOFTWARE
If anyone is able to provide suggestions but needs more information about my hardware and software configuration, please let me know.
QUALCOMM QCA9377 802.11AC WIRELESS ADAPTER DRIVER DRIVER
I'm curious if there's anyone who has used this module with a better driver who can help. If anyone is curious where this module was purchased from for context ( AliExpress): Subsystem: Samsung Electronics Co Ltd Device # lspci -knnĠ2:00.0 Network controller : Qualcomm Atheros QCA9377 802.11ac Wireless Network Adapter (rev 31) I'm not sure what the above error is specifically caused by, since I've seen it only spit that error when transmitting and/or receiving at a certain rate (above 1 megabyte per second approximately). It works, however unpredictably (1-15 seconds approximately) during traffic I get the following error: hostapd: wlan0: STA XX:XX:XX:XX:XX:XX IEEE 802.11: disconnected due to excessive missing ACKs (from logread) This card seems to work without issues in client-mode, however has an odd problem when in access-point mode.
QUALCOMM QCA9377 802.11AC WIRELESS ADAPTER DRIVER INSTALL
Hence why I needed to manually install the firmware file. I've checked the OpenWRT SDK for my device(U7621-06) and was only able to find support for the USB version of this module unfortunately. However since the software repositories do not have support for the card I had to manually install the firmware file from here( GitHub): I recently installed a Qualcomm Atheros QCA9377 (mPCI-e version) into a OpenWRT/LEDE based router.